Bercomac 700416 Bedienungshandbuch PDF herunterladen (Seite 9)

ASSEMBLY

NOTE: The front brush guard (option from John

Deere) must be removed.

Install the front frame (item 1) on the tractor’s frame

by inserting the shaft (item 2) into the hole in the front

axle.

Pull the knobs (one on each side) (item 3) and hook

the front frame on the hooks (item 4). Release the

knobs.

Make sure the pins are well entered into the holes

(item 5).

FRONT FRAME INSTALLATION:

MODELS X475, X485, X495, X700, X720, X740

IMPORTANT: TORQUE ALL BOLTS ACCORDING

TO TORQUE SPECIFICATION TABLE (SEE TABLE

OF CONTENTS) WHEN STATED: TIGHTEN FIRMLY.

REFER TO PARTS BREAKDOWN SECTION FOR

THEIR IDENTIFICATION.

WARNING

TO PREVENT INJURIES:

Park the machine on a flat surface.

Disengage the P.T. O.

Lower the attachment to the ground.

Apply parking brake.

Stop the motor and remove the ignition key.

Wait until all moving parts have stopped before

leaving the driver’s seat.

Install the shaft support

Install the front frame

If the front P.T.O. is required, proceed as follows, if

not, go to the next step.

Install the shaft support (item 1) on the front frame

(item 2) with two 1/2 x 3 3/4" hex bolts (item 3).

Secure with two nylon insert locknuts (item 4).

Tighten firmly.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 55 56

Keine Kommentare

Bercomac 700416 Bedienungshandbuch Seite 9