Bercomac 700416 Bedienungshandbuch PDF herunterladen (Seite 13)

ASSEMBLY

Install the handle support (item 1) by unscrewing the two

bolts in place (if installed) and secure with two 1/2 x 1

1/4’’ hex bolts (item 2) and nylon insert locknuts (item 3).

Tighten firmly.

Install the plastic grommet (item 4) in the handle support

(item 1).

VERY

IMPORTANT, BE CAREFUL NOT TO LET

ANY DIRT GET INTO THE HYDRAULIC SYSTEM.

Unscrew the hoses (item 1) from the adaptors (item 2)

and reinstall the hoses on the right side of the frame as

shown by taking care to turn the adaptors in order for

the hoses to be as straight as possible.

Unscrew the quick coupler male (item 3) and screw the

two 90° adaptors (item 4) into the quick coupler male,

making sure to install the dust caps (item 5). Add some

Teflon sealant on the threads. Screw the 90° adaptors

(item 4) on the hoses.

Connect the hoses by following these steps: Thread the

hoses under the round tube of the front frame, on the

channel over the axle, and under the frame on the right

side. Connect the hoses to the quick couplers (item 6)

(top section) of the hydraulic valve. Tie the hoses to the

frame with a nylon tie wrap so that they do not touch the

tires.

NOTE: In order to make sure that the hoses are well

installed, pull the hydraulic lift arm towards you, the

attachment must lift at least 4’’ off the ground. If this

is not the case, reverse the hoses.

WARNING

TO PREVENT INJURIES AND FOR MORE

TRACTION WHEN USING THE ATTACHMENT:

-Rear counterweight of 150 lbs. minimum is

required to counterbalance attachment’s weight.

-Tractor manufacturer approved tire chains are

required.

-Do not operate on a slope greater than 10°.

-When dismounting the attachment remove rear

counterweights.

Modify installation of the hoses

Install the handle support

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Keine Kommentare

Bercomac 700416 Bedienungshandbuch Seite 13